Motorcycle Foot Pegs Foot Rest Highway Footpegs Compatible with Road King Street Glide Honda Kawasaki Suzuki Yamaha 25mm 32mm 34m (Black)

These look fantastic on my Kawasaki 1700 Vaquero. Be sure to fit the shims they give you as it aids in there being a way to raise and lower them. I've waited a couple of weeks to review this as there were some issues. 1/1/4 inch bar owners you will have no room for shims or anything else at all so be prepared to risk marking your crash bars. I managed not to putting them on but i will have if i take them off. The clamping mechanisim is such that they require four small screws to be undone on a plate that i thought would not hold. It has so far and it's all stayed tight. I don't fully strust them with my life yet so do be careful as if these fail and your foot falls off you could litterally have an accident. Saying that ive seen no weakness from them and at one thrid the price of Kurayaken foot pegs which i have had slip before they are a bargain.

For the price, I thought these worked very well. Ordered for a 12 hr drive and they performed well. No instructions, but you shouldn’t need any. Very simple. Just keep the little flat silver piece in when you attach peg to mount. It helps hold it up

These are heavy duty highway pegs. Easy to assemble and comes with everything you need to install. It comes with a few parts that the directions do not say how to install. The small silver metal brackets are to be installed in between the foot rests and the pivot point of the clamp side. These are to provide some resistance when rotating up for storing. The small black button caps are to cover the silver adjustment bolts on the end of the pegs to hide the silver bolts. Not too hard to figure out but slightly confusing for some. Hope this helps. Overall heavy duty and looks great on the motorcycle.

Ordered in September for a Christmas present for my husband and here it is December 27th, he tried to put them on and the freaking housing cracked on BOTH. Of course the return window is closed. WASTE OF $$$$ and a crappy Christmas for him

The primary problem with these foot pegs, is they come with plastic shims to accommodate different diameter bars for installing on to. The shims are necessary, however, the fact that they are a smooth plastic is a problem when you mount thm on a smooth metal bar (motorcycle frame, crash bars, etc.) they have the tendency to slide down the bars when you put the weight of your feet/legs on them. It doesn't matter how hard you tighten them they will slide slide down. What is needed, is for the shims to have a thin rubberized coating on the inside, or a peel & stick rubber insert than can be pasted inside them.I just installed a handlebar phone mount from Tiakia. This phone mount had very similar shims and Tiaka was astute enough to provide rubberized paste on pads for the shims. A great phone mount by the way, so I pasted their link below my review.At any rate, to alleviate the issue, I took an old tire tube and cut my own rubber strips and glued them inside the shims. This stops the sliding.On another note, no installation guide was provided. Not a problem for many, but I think others could benefit from some directions. I had no problem mounting them, however, the parts shown in the pic I uploaded were left over. I have no idea what they are for and saw no need for them.Tiakia Phone mount(https://www.amazon.com/dp/B09TDL664Z?ref=ppx_yo2ov_dt_b_product_details&th=1)

Pegs do a good job

Easy to install. They came already put together. They seem to be heavy duty and look great on my bike. And a great value

The material quality is fairly nice, the rubber inserts are thick and soft enough to grib a smooth bottom shoe. They fit nice and tight on 1"/25mm tubing with the supplied reducers. The black matches well with most bars. Overall a good value for the price.