uxcell Sleeve Bearing 8mm Bore x 10mm OD x 15mm Length Plain Bearings Wrapped Oilless Bushings 10pcs

As described. Worked perfectly

Saves on using washers.

I used these to help replace my broken luggage wheels. The replacement axles were 6mm so they worked perfect to fill the gap and provide a low friction surface. Only issue is they were too short. Needed a 20mm long one. Solution: use two 10mm in each wheel.

Use to replace the OEM one combine with dowel and other bushings had made the steering pole more solid and responsive. Can tell its a day and night difference

If you're designing stuff for your 3d printer, these are as great as they are hugely overkill (I love overkill) and they take very little valuable real estate. Needle bearings are good for what they are good for, but I find them over-used when something like these are perfect for low-speed rotary applications and even better for most any pin-and-linkage jobs. I was worried about the wrapped copper but it's pretty well executed. I might be a little more careful were I doing precise machined parts, but for plastic stuff that requires a little better than plastic or bronze plain bearings, these are perfect.

I used these sleeves on some threaded rod to ride against the bearings on my whirligig axels. Very smooth.

They worked perfectly for front shifter bushings on my 1996 Subaru Sambar 4WD 5 speed KS4.

i needed a bushing for an aftermarket clutch lever and this worked perfectly. snug fit on the OD, but that is what I wanted. they are not all the same, tolerances are out by 0.02mm or so give or take, but I just needed one and found the best one in the bunch